Flat work iron machine — irons and dries bed sheets, table linen, and sarees in one continuous pass. Steam, gas, or electric heated.
Steam, gas, or electric — you pick based on what your facility runs
Gas, steam, or electric — you pick based on what your facility runs. All three hold a consistent temperature across the roller. Lower BTU consumption than conventional ironing equipment means the running cost is predictable.
FRONT FEED , REAR RETURN
MODELS
FIS 18
1 ROLL
FIS 36
1 ROLL
FIS 24
1 ROLL
FIS 34
2 ROLL
PRODUCT SPECIFICATION
Built the same way as the larger models
On this model, linen feeds in from the front and comes back out the front. That means the machine can sit against a wall — you don't need clearance behind it. Useful when floor space is tight.
Bearings and belts accessible without dismantling the roller
When something needs attention, the bearing housings and feed belts are reachable without taking the machine apart. Most routine maintenance takes under an hour.
AVAILABLE MODEL
400 X 1600 LENGTH
Small calender — 400 x 1600 mm. Front feed, front return.
Compact footprint — front feed and front return from the same side
AVAILABLE MODEL
800 X 3000 LENGTH
1,2 ROLL.
Large calender — 800 x 3000 mm. 1 or 2 roll. Front feed, front return.
One or two rollers — pick based on your throughput requirement
Single roller handles most commercial hotel and hospital volumes. If you're running a high-volume laundry where sheets move through continuously across multiple shifts, the two-roller configuration doubles your ironing capacity without doubling your floor space.
800 mm wide — handles full-size bed sheets in a single pass
A standard hospital or hotel bed sheet is around 250 x 300 cm. At 800 mm roller width and 3000 mm length, this machine irons the full sheet without folding. One pass. Consistent press edge to edge.